Recent questions tagged design-of-tension / GO Civil

0 votes

0 answers

1

GATE2016-2-37
Two bolted plates under tension with alternative arrangement of bolt holes are shown in figure $1$ and $2$. The hole diameter, pitch, and gauge length are $d$, $p$ and $g$, respectively. Which one of the following conditions must be ensured to have higher net tensile capacity of configuration ... shown in Figure $1$? $p^2 > 2gd$ $p^2 < \sqrt{4gd}$ $p^2 > 4gd$ $p > 4gd$

Two bolted plates under tension with alternative arrangement of bolt holes are shown in figure $1$ and $2$. The hole diameter, pitch, and gauge length are $d$, $p$ and $g...

Milicevic3306

11.9k points

Milicevic3306 asked Mar 27, 2018

0 votes

0 answers

2

GATE Civil 2013 | Question: 33
A uniform beam weighing $1800 \: N$ is supported at E and F by cable ABCD. Determine the tension (in $N$) in segment AB of this cable (correct to $1$- decimal place). Assume the cables ABCD, BE and CF to be weightless. _______

A uniform beam weighing $1800 \: N$ is supported at E and F by cable ABCD. Determine the tension (in $N$) in segment AB of this cable (correct to $1$- decimal place). Ass...

Milicevic3306

11.9k points

Milicevic3306 asked Mar 25, 2018

0 votes

0 answers

3

GATE Civil 2012 | Question: 35
Two plates are connected by filler welds of size $10$ mm and subjected to tension, as shown in the sketch. The thickness of each plate is $12$ mm. The yield stress and the ultimate tensile stress of steel are $250$ MPa and $410$ MPa, respectively. The welding is done ... mm) of each weld to transmit a force $P$ equal to $270$ kN is $100$ mm $105$ mm $110$ mm $115$ mm

Two plates are connected by filler welds of size $10$ mm and subjected to tension, as shown in the sketch. The thickness of each plate is $12$ mm. The yield stress and th...

Milicevic3306

11.9k points

Milicevic3306 asked Mar 25, 2018